Thermion2 xp50 pro clarity issues

travislhd

New member
I turn on the scope and soon after I focus i am constantly refocusing I am seeing snowy images and it's like the refresh isn't doing it's job entirely?
Also there appears to be a circular shadow in the view finder at times?
Anyone any ideas?
 
I don't have one, but it sounds like the shutter isn't closing fully when it NUC's. Try going to manual NUC and follow the instructions and see if that resets it when you go back to auto or semi-auto NUC.
 
Double Up has a great suggestion. You could also try putting you hand tightly over the lens when the counter starts to countdown for auto nuc.
 
Will the scope need to be zeroed after the reset ?
I have a Thermion 2 XG50 LRF. One time I noticed that the external battery pack I use wasn't charging the scope and the scope wouldn't charge with the Pulsar supplied charger either. I contacted my dealer and they told me that they had heard of this happening on occasion and the recommended fix is to do as El Jefe suggested above and turn the scope on, hold the power button down until it powers off and back on. This fixed my issue and I believe a subsequent firmware update corrected this from happening again. I did take a screen shot of my XY zero coordinates before I tried this just in case but the scope kept my XY zero coordinates so it was a non issue. I haven't run into any clarity issues though.
 
Back
Top