Powder Funnel for fine Powders

[TXCOONDOG]

I've always used a universal powder funnel with stick type powder. However, using fine powders tend to go in between gaps on my 20/22 cal necks (204, 223, 22-250, 22-creed, etc).

Hoping ya'll can make a recommendation, so I don't have to go through a lot of trial and error.

 

[SixsixtyMags]

May not be ideal, but I use a 3 1/2" piece of 1/4" ID clear heavy wall, not the thin stuff, flexible plastic tubing and snug it up inside the funnel to load for .223 and 22-250. I'm sure there are better ways but that has always worked for me after experiencing the same problem, will be watching for what others have to say.
It's not a perfect fit, but the tube usually stays in place to put it over the case mouth, once the funnel and tube are over the mouth, then by just holding onto the lip of the funnel with minimal pressure will apply enough pressure to keep everything in place, probably could wrap some electrical tape around the tube in order to provide a snugger fit.

 

[Lazer32]

I use Satern funnels. They are aluminum and keep static to a minimum. They are also caliber dependent so you have to buy one for each caliber but I've I don't get any spillage and they are super sturdy.

 

[hm1996]

LYMAN POWDER FUNNEL

 

[derbyacresbob]

I use the 17 cal fitting on my funnel to put powder into 22 cal brass to prevent powder spillage.

 

[AWS]

I use the Lyman powder funnel set but it only goes down to .22 so I have a I believe a Saturn for my .20 and a long droptube for stick powders.

 

[DiRTY DOG]

Saturn.