6mm06
I cut some cedar logs and sawed them out on a sawmill. I used 2X2’s to frame the walls and ceiling and 2X4’s for the floor 4X6’s for two skids. We notched the 4X6”s and inset the floor joists. ½” cedar board and baton on the outside walls. The door will be going on tomorrow as well as ½” X8” Teflon skies over the skids. I will be covering the inside walls as well. Even thou its cedar its far from light but with the 8” wide Teflon skies my Bear Cat with a 22” wide track will tow it 25 mph on good going.
I am also building 2 smaller shooting shacks. I am building a 4’X8’ frame from 2X2”s 1 foot on center cover the bottom with 1/8” Luann plywood spray foam the frame then cover the floor with ½” plywood. We are framing the walls with 1X2’s and covering with a cotton sheet (for the outside walls). Then we are painting the sheet on the outside walls with epoxy paint then spray foam the inside walls and roof. I will have 1 bunk and a shooting window and a small heater. I am using 2- 2X4’s for skids covered with Teflon. This should be a very light portable hunting blind that will fit between the wheel wells of a truck.
My buddy has a spray foam business so he can spray foam insulation in these in about 5 min and it makes the structure rock solid and very warm and light.
